In der neuesten Cura Version (15.01) kannst du auch in der "expert config" das "combing" auf "No Skin" einstellen. Dann werden diese Linien auf Oberflächen ausbleiben.
@Nicolinux: Danke! Die Einstellung kannte ich auch noch nicht. Gruss, Obi
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 27 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
obolski 0
Hallo 3Dnerd
Um dieses Überfahren der fertigen Oberflächen zu vermeiden, kannst Du das Cura-Plugin 'Retract while combing' benutzen. Damit kannst Du einstellen, bei welchen Layern diese Linien vermieden werden sollen, und evtl. auch den Druckkopf etwas abheben (Lift Head during Retract).
Gruss, Obi
Link to post
Share on other sites