Thanks! i'll have to spend money though :(
I'm near you, in Melbourne, but as Didier mentioned, there is some cost involved in shipping a sample to you, as well as the print itself. The cost of a small sample compared to the outlay of the printer itself is almost certainly negligible.
Feel free to share the sample print so that we can at least see if you are after a simple whistle, or some complex object which will take some time and tuning to get right.
-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
DidierKlein 729
Hi,
I'm not sure anyone might send you a free print, but who knows?
I would advise you to go to 3dhubs.com and find a hub near to you with the Ultimaker Bagde (to print samples)
Link to post
Share on other sites