Ok this explanation I can understand.
But honestly, if I get an UM2 and have to tweak temperature and speed settings and now also turn off the fan I doubt that this is 'normal'. My UM2 is only a few weeks old.
What I expect from UM2 is insert filament, tell UM2 which one I have, use 'Fast print' settings in Cura and start printing.
Is it normal that I have such problems?
Recommended Posts
dirkdirk 5
You have to use a plugin when you want to deactivate the fans for a specific layer. TweakAtZ
If the coupler is deformed the material doesn't comes out in the calculated "form/amount". This is the only understandable reason for me..
Link to post
Share on other sites