Drôle de question....
Mon capitaine veuillez activer la Porte à faux !
Comme @alain , j'imagine que tu dois vouloir activer les support ?
Drôle de question....
Mon capitaine veuillez activer la Porte à faux !
Comme @alain , j'imagine que tu dois vouloir activer les support ?
Drôle de question....
Mon capitaine veillez activer la Porte à faux !
Comme @alain , j'imagine que tu dois vouloir activer les support ?
En quoi ça serait une drôle de question!!!
Restons calme, nous seront de retour ce soir à la maison pour embrasser nos femmes et nos enfants ainsi que sentir le poulet rôtir dans le four
C'est une drôle de question car par définition un porte à faux "ne s'active " pas, un porte à faux est crée par la main de l'homme lors de la conception 3d de la pièce.
Ce qui " s'active " c'est la gestion de supports pour palier au dit " porte à faux ".
...et pour moi, ce sera une cuisse...
Recommended Posts
alain13260 1
Ben faut activer les supports dans Cura. C'est dans la page "simple" ou "basic" de Cura, en bas, avant-dernière ligne "type de supports " .
Ca sert à ça !
Link to post
Share on other sites