Cura (Mac) Hangs After Long Print

[waitinggame 0]

I am running Cura 15.02.1 on a Macintosh Running OSX 10.10.2 (Yosemite) with a Printrbot Simple Metal.

I am relatively new to 3D printing but two weeks in, I have had many successful prints and for the most part I am scaling the learning curve nicely. That being said, I am having a problem with Cura hanging after a long print (4+ hours). This does not happen every time after a long print, but it does happen most of the time.

When Cura hangs, the rest of the system remains useable and stable - but Cura give the spinning ball of death. This sometimes happens while the print is still in process, but the print continues without incident. Ultimately, the only cure for the spinning ball of death is to force-quit the application.

The first time Cura starts up after the force-quit, it runs the start up wizard. This might make some sense if Cura had crashed upon its first run, and had not had a chance to save the preferences, but this occurs even when Cura has been launched and quit serveral times before the hang-up.

I checked the console logs, and do not see anything that jumps out at me, but I did note that a separate diagnostic crash log has been saved. No help to me, but may be a help to someone else.

The hang-up is more of an annoyance than a major problem, but if anyone else is having this problem, misery does love company. If anyone has found a cause or even better a solution that would be welcome as well.

Thanks, WaitingGame

 

[amedee 349]

I had that on a regular basis -- just as you say: print works well up to the end, but lost control over Cura.

No problem any more these days since I always print from SD :unsure:

 

[juhnke 0]

Plus 1! I find a zombie process in Activity Monitor and have to force quit it between prints.

OSX 10.10.3

Cura 15.04

[peterlrowley 0]

I've had this problem a couple of times now, most recently tonight. With Cura 20.01 running under OS X El Capitan (10.11.6), it appeared to hang just 11 seconds after hitting the 3 hour mark. As others have reported, the print finishes fine, but this makes the progress indications for the latest version of Cura of limited use for long prints.

[ahoeben 1,955]

Cura 20.01 is published by Lulzbot. Please report issues with that software there. At Ultimaker we're focusing our effort on the Cura 2.x releases.