Grommet

[kepolas 2]

Hey everyone. This is probably stupid question but does anyone from Ultimaker or anyone here in forum knows if its possible (and how) to get this little thing for stock feeder on UM2...? I have "older" version of Ultimaker 2 without this grommet and one "new" with it and id like to use it with roberts feeder on my "older" UM2 as well.

Thanks!

[stu_le_brew 42]

Not 100% sure which part you mean, if its the part that holds the Bowden tube in place then you can get them from Swordiff's site (http://3dsolex.com/) - which is quicker and cheaper than Ultimaker

Edited May 19, 2015 by Guest

[kepolas 2]

No no, not that. I mean the metal thing where filament enters the feeder.

Edited May 19, 2015 by Guest

[reibuehl 42]

No no, not that. I mean the metal thing where filament enters the feeder.

 

Sorry to dig out this older thread, but have you found a source for the feeder entry grommet?

[ultiarjan 1,223]

Don't use it myself but I think I've seen people use these things you just get a the hardware store.