paul9

Hello guys, some of you have already used this type of PLA riclato? You can give me more information on the print result obtained with this type of RPLA?

How do proper cleaning and lubrication z axis then?

There is a guide that shows how to clean and how to properly lubricate the z axis. I've cleaned and lubricated in this way: I took a piece of soft paper ones you use to dry your hands, and I passed on the z axis, then after we have passed the green lubricant.

Hello guys. I wanted to ask how you can avoid having the walls like that, where they are very showy lines of various levels. This may depend on the fact that the PTFE is very worn or from the feeder or even from the pulleys of the axes that move the extruder?

You can send the link for the tool fix by 3DSolex

Tahank you! This video is perfect for me!

OK Thank you but I have the new temp sensor and heater! So I have to replace them.

I have requested information for replacement starting from the motherboard Arduino up to the extruder block. In the video there is not any of that!

Hello everybody! I was not able to re-use my temperature sensor and my heater because you are stuck inside the extrusion block. Now I took a block from olsson 3DSolex, but I have to remove the old block with the temperature sensor and the heater and sostiutire everything with new parts. There is a video that shows how to properly carry out the operation of replacing heater and the temperature sensor?

very good print! :-D

The lubrication of the screw in the z axis is OK. For the rest I do not know if there are other problems.

I have Ultimaker 2 . This happens not on the first layers but at a medium to medium-high and even height.

What do you mean by stability bars underneath there bed?

It is framed building vibration increases.

Hi everyone. I just happen with some slightly more complex prints, to hear and to see that while the extruder moves without printing, the subbisca plate vibration, there is a way to avoid that during the movement of the extruder does not happen that the plate vibrate excessively so? What could be the cause?

The Ultimaker gave me directions to solve my problem with a retailer in my area.

I purchased on Ultimaker site, today I wrote an email (support@ultimaker.com) to them enclosing a photograph of problem, I hope that will help me.

Hi, What do you think of this? http://reprap.me/um2-extruder-plastic-frame-set.html

Thank you!

Thank you!

Also you can take the source file (step), convert it to a STL and print it. Where can I find it? There is no solution by ultimaker?

Hello everybody. It suddenly formed a small fracture in this area. You can just buy this component to replace it, I feel that one of these days will break completely.

After 20 August will start to assemble and then I may need help.

Thank you neotko and Labern