paul9

PRINTING PROBLEM Today I have performed all the controls on the steppers of the stepper motors and also on the axle screws I tightened all the screws well and adjusted the straps as proposed on the following guide: http://support.3dverkstan.se/. ..ooting-guide # circles Setting Print with CURA 2.6.1 I have the following problem printing object is unacceptable, the object is cropped, cropped.

Hi Thanks, today I have been upgrading to the belts attached to the stepping motors.

Material PLA Temp 208 Cura 2.6 size nozzle 1mm from 3D Solex

I have feeder bondtech, and I I cleaned and lubricated the z axis.

Hello everyone, what factors can depend on this type of problem? I hope someone can help me.

Thanks a lot, I realized it too late.

Hi everybody, I can not understand why care does not allow me to print an object often 1 mm and with dimensions 220mm x 200mm. Can someone help me?

I have made a first printing using Cura 2.4 not having the preview as of version 2.5 I have not seen the result, but if I had installed and tested with version 2.5 maybe now my press would be much better.

Exactly

You don't. This is why i was not so sure we should have this feature. But all the other slicers had it and at some point we also had to participate. Because if we don't, people keep using the lack of a "realistic" rendering as an argument why Cura is falling behind. If you want a perfectly right layerview, it's going to take a loong time to build. You would need to take a whole lot of physics, material flow, deformation, etc into account. Thanks

In fact I made this print using Cura 2.4 where, however, do not have this print preview, and the result was just like you see in the preview offered by Cura 2.5, that's why I wrote realistic.

Hello everybody! With CURA 2.5 (beta) I'm simulating printing using a nozzle of 0.6 and one 1mm, when I preview in layers with the same settings, but only changing the nozzle and entering what I get from 1mm problems similar to under-extrusions in parts printing more important. Some of you can help me solve?

Thanks IRobertl This guide is valid for cura 2.3?

Hi guys, I printed using I Cura 2.3.1 I think that is a problem of care settings, because this happens every time the plate is lowered and a new level of printing

Hi guys, How can I avoid making this bad form line that occurs each time you lower the level of a dish? I hope someone can help me. Thank you

Thanks for the feedback. I look forward to seeing some great pictures of interesting prints.

Hello to all. According to you when he is the right time to change the belts and axes of UM2 printer? There is no rule or timing related to printing hours worked?

The problem was solved simply by installing Cura 2.3. Thank you all.

Hello guys. I wanted to know if you can use the new Cura with the firmware realized by Tinkergnome. Have any of you tried it?

Thank you for these your important information.

I just tried the new nozzle of 1 mm was fantastic, the times are reduced considerably!

Hi guys! The first printing layer immediately after the media is printed as if the material came out from the extruder to sob. According to what you can depend on this problem?