paul9

Hello everybody! I know some of you find this as a component marked with the red arrow. I think it is a screw nut m3 but I would like to confirm, or maybe a link to a few pages to figure out exactly what it is. Thank you

Hello everybody. Looking at these images you understand that there is normal wear and tear. What I wanted to know is, it is fine to clean up these areas by removing debris that formed ?.

Hello everybody. I wanted to ask how to change the parameters carefully computed on the Olsson block nozzles. For example with the nozzle by 0.8 as set in such a way appropriate to the height of the levels? You can be set for example a height of 0.3? I would like to understand what method to use to set adequately the new extruding parameters with a nozzle 0.8.

Do you think this also has to be replaced?

How can I tell if I have this version or not? I can notice it before you mount it?

I understand perfectly. Thanks so much.

Hello everybody. I wanted to know if any of you who mounted the Olsson BLOCK V3 MATCHLESS of 3dsolex left the old temperature sensor and the old hotend Heater 25 Watt and is fine. Or it has replaced these two parts or one of them.

Because I could not get it done to go back to my friend and then I tried a printable solution ABS.

Hello everybody. Some of you have mounted the Olsson block Matchless V3 3D Solex without changing the 25-watt heater and the temperature sensor? How is it? Works well? I have provided the Heater from 40Watt but do not know whether it makes sense to replace it instead of the original one or not?

Hi swordriff, You're already using the 1.75-mm system?

Hi neotko, which of these two thou hast taken for conversion to 1,75mm? To 5mm or 8mm what? It is mounted on the axis of the feeder in this UM2?

thank you so much

I saw that you have replaced the spring with the ring. Where did you find him? Where can I find it?

Thank you!

Ok neotko Thank you

What I mean me and changing the rotating parts that push the wire, how you change that part?

Hi cloakfiend, what brand of filaments you used to make prints that you see in these video tutorials?

Hello everybody. Any of you who has a Ultimaker printer has used this strand PolyPlus PLA? What qualities do you get? How he behaves during printing? it is true that it is better than normal PLA in terms of mechanical strength?

but change helical wheels where it is pressed and runs the wire

No