Framar

Here the STL file in Question tir7.stl and the setting used And Here is the result:side walls have no top layers

Bonjour, J'obtiens le même résultat lorsque je slice le modèle 3D. J'ai trouvé qu'il y avait une erreur avec votre fichier .STL. Le trou au centre ne se rend pas jusqu'à la surface du bas OU il manque la surface au fond du trou s'il ne doit pas déboucher. Voir sur image ci-contre..

Hi Smithy, Well, I did try different line width and the result is the same: no top layers. That was until I turn on the infill, then I got what I wanted... But why the infill is iportant to get top layers ???

Hi all, I ran into a situation that I still not understand. I have a model: drawer divider that has 1,6mm wall. I want to print this part with a Ø0,8mm print core. If you look at the first picture on the left, you can notice that there is no top layers, just one Inside and oune outiside wall. If I do add some infill, then I get top layers; see picture on the right... What is the relation between infill and top layers??? I don't get it.

Hi everyones, I just got a S5 and this is my first post on the forum. I would like to know how the flow sensor on the S5 is suppose to work? I did had some issue printing with generic PLA. The filament broke a few times over a few prints and unfortunately, everytimes,the printer was just continuing running. I would have except the flow sensor to stop the print... How can I test if the flow sensor if woring fine? Thanks!