Hi!
You can have to LITTLE bed gap also. The hole is very tiny so if it touches the glass nothing comes out.
PLA prints at 210-215 initially until you have more experience.
If you change to ABS (245C++) then residue PLA will burn and stick inside nozzle.
Solution: 2-10 ATOMIC pulls. Search the site or www.3dverkstan.se (Bet service in European history), support pages.
Recommended Posts
Bigeye 1
Thanks, I will try but for now I ran into another problem: the filament (PLA) doesn't come out. So I refed the material. It seemed to work at first, material coming out from the nozzle while feeding. But when I started printing again, nothing. Can the nozzle get clogged?
Link to post
Share on other sites