Cura 15.06 / 15.04: Spiralized Vase, Stutter Scar

[nallath 1,123]

As the new Cura Engine was built to be enhanced by plugins.

 

Just a quick correction; The Cura GUI is built to be enhanced by plugins. The engine has no such feature (yet... Dont expect it very soon).

[goose_busters 0]

how can you turn on vase mode in cura 15.04.6 I have a creality CR-X and only has a config for an older version of cura, I'm also fairly new to 3D printing. 

[tinkergnome 927]

1 hour ago, goose_busters said:

how can you turn on vase mode in cura 15.04.6 I have a creality CR-X and only has a config for an older version of cura, I'm also fairly new to 3D printing. 

 

From the menu choose: "Expert" -> "Open expert settings...", and enable "Spiralize the outer contour" in the "Expert config" dialog.

Good luck!

 

[goose_busters 0]

thanks tinkergnome! My next print will be a vase! I will post it when finished

-goose buster-