UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The fans need around 25% to 30% to get started. Once moving you can lower to around 20%. Maybe even lower. There is a feature that if you go from *off* to 20% it over powers the fans at 100% for a half second or so then lowers to 20%. This works great and jumpstarts them but if the first layer is 5% and the second layer is 10% it only jumps 0-5% and not 5-10% so the fans don't come on until around 30%.
by the way the % represents the duty cycle. So if the fan is at 50% that means it is at full power/voltage for half the time and off the other half the time. The cycle is 5 to 10 times per second. Same method for setting power to the heater in the nozzle.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
The fans need around 25% to 30% to get started. Once moving you can lower to around 20%. Maybe even lower. There is a feature that if you go from *off* to 20% it over powers the fans at 100% for a half second or so then lowers to 20%. This works great and jumpstarts them but if the first layer is 5% and the second layer is 10% it only jumps 0-5% and not 5-10% so the fans don't come on until around 30%.
by the way the % represents the duty cycle. So if the fan is at 50% that means it is at full power/voltage for half the time and off the other half the time. The cycle is 5 to 10 times per second. Same method for setting power to the heater in the nozzle.
Edited by GuestLink to post
Share on other sites
IRobertI 521
It also differs between fans. Some come on earlier than others.
Link to post
Share on other sites
mechamecha 64
Ah, I get it now. Thanks!
Link to post
Share on other sites