Making a big Teflon piece

[pm_dude 27]

Hello,

I'm prototyping a piece for a client and the original piece is made of teflon very similar to the white insulator we use in the UM2. The goal would be to get the same material for the final piece.

Any one know where it can be made?. The piece is mainly cylindrical and about 3 inches wide by 6 inches tall.

Ideally we are looking for a source from Canada or USA but its not a must.

Edited September 1, 2015 by Guest

[gr5 2,265]

 

@swordriff is an expert at this kind of thing.

[swordriff 119]

That is big piece! Please, can it not be made of something else?

[pm_dude 27]

Yeah after checking again with the person its made of some really hard and slippery plastic. The feeling is the same In that case it may just have been molded.

[swordriff 119]

how about this one or similar...

http://www.ebay.com/bhp/teflon-block

[pm_dude 27]

Turns out its Polyoxymethylene

[swordriff 119]

Are you going to inhale?

[pm_dude 27]

The part is for some bakery equipment so it will be in contact with food.