Please see the attached photo.
This model was the 1st of an array of bad prints and seemed that the nozzle was dragging through previous layers which caused the model to spread out.
Now it seems that that no were near enough material is being extruded through the nozzle for it to print at all, potentially a feeder issue?
Recommended Posts
gr5 2,224
A photo or video would be helpful. There are 3 possible issues you are describing each totally different.
First realize that leveling only affects the first layer. by the time you get to the 3rd layer all leveling has been self repaired by the fact that each layer sits on the previous and eventually they get to the right position. This is easier to show in pictures than words.
Is your problem top and bottom layers only? If so try turning off the "combing" feature - that will make a huge difference. And make sure retractions are enabled. Please post picture.
Link to post
Share on other sites