UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
(edited)
· ended Community Contest, part 2 | The Ape.
made one layer of spikes: copied 44 ones radial, copied this layer above with a distance of 0.2 mm (layer thickness) and rotated slightly. copied these two layers over the whole body with the layer height distance. Made an offset from the body, about 3mm wider en split the spikes with this. Most work was removing the acces spike stuff, but this way the outline follows the body.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
peggyb 171
made one layer of spikes: copied 44 ones radial, copied this layer above with a distance of 0.2 mm (layer thickness) and rotated slightly. copied these two layers over the whole body with the layer height distance. Made an offset from the body, about 3mm wider en split the spikes with this. Most work was removing the acces spike stuff, but this way the outline follows the body.
Edited by GuestLink to post
Share on other sites