UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
(edited)
· First load of ultimaker 2 is grinding fillament
You need to sharpen the filament like a pencil. It can sometimes get caught on an edge going into the nozzle if it has a flat end. Maybe caught on the PTFE coupler or something.
Also make sure the bowden tube is going all the way into the PTFE Coupler and everything is seated nicely. ( Olsson Block isn't on a weird angle or anything)
Posted
· First load of ultimaker 2 is grinding fillament
Usually if you just wiggle the bowden tube a little bit when the filament stalls it will get going again. You'll hear it click as it gets past the edge it was stuck on.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Labern 774
You need to sharpen the filament like a pencil. It can sometimes get caught on an edge going into the nozzle if it has a flat end. Maybe caught on the PTFE coupler or something.
Also make sure the bowden tube is going all the way into the PTFE Coupler and everything is seated nicely. ( Olsson Block isn't on a weird angle or anything)
Edited by GuestLink to post
Share on other sites