Ultimaker 2 Extended - 1.0mm nozzle(toothpaste) test

[RetromanIE 41]

Finally got around to trying out the 1.0mm nozzle(Olsson block etc).

It's pretty silly looking, and I see why it's nicknamed the toothpaste nozzle

Handy for super quick low resolution prints though.

 

0.8mm layer height

230c printing temp

60c bed

15mm/s

Colorfabb traffic light red PLA

Sliced in Simplify3d

And yes, i know my fan shroud looks a mess. But it works great after I modded it with some Sugru

I got sick of the custom shrouds warping and generally not going well for me. I used the sugru to improve the noise/vibrations and even airflow a little on the original version.

Actually, could i paint it I wonder to improve the look?

Edited January 25, 2016 by Guest

[eldrick 65]

The 1mm nozzle works fine at more reasonable layer heights. I'm getting excellent PQ on single-wall "vase" prints at .25mm.

[RetromanIE 41]

Yes, I'm sure it would look better at a normal res

But i did a vase today at 0.7mm and it actually suited the style of the vase quite well.

[LePaul 326]

Wow, what is that "hood" you've made?

Love the dinosaurs!

[RetromanIE 41]

Wow, what is that "hood" you've made?

Love the dinosaurs!

 

I bought the hood from a 3d printer store in Germany(can't remember the name, but the owner is registered on here i think). It's pretty great, but the clear plastic is acrylic and gets scratched up, I might replace that with polycarbonate sheets at some stage(maybe when getting the a door made up).

The dinos are just some vase mode prints i was testing out.

[eldrick 65]

The 1mm nozzle works fine at more reasonable layer heights. I'm getting excellent PQ on single-wall "vase" prints at .25mm.

 

I should add that this is at 40mm/sec speed, moving 12mm3/sec. of filament. (Bondtech feeder, 35W heater)

[frederiekpascal 193]

Wow, what is that "hood" you've made?

Love the dinosaurs!

I got the same top cover, I can recommend this

It's been sold here

cheers

[LePaul 326]

I'm still saving for my Ultimaker 2 + !

Good to know!