Hi,
What is the printing temperature?
Do you have values in the advanced tab for speeds? Infill speed?
The walls look correct from what i see
I put infill speeds from the advanced location in my initial post. The printing temperature and all settings within the automaker itself is from the manufacturers factory settings. The walls do come out good but remember that the walls are being printed slower in my settings. The infill is slowly getting worse. It makes no sense to now slow the printing of the infill to match the slowing of the filament. I want to correct the problem not bandage the symptoms.
Edited by Guest
Recommended Posts
DidierKlein 729
Hi,
What is the printing temperature?
Do you have values in the advanced tab for speeds? Infill speed?
The walls look correct from what i see
Link to post
Share on other sites