robson 1 Posted April 8, 2016 in 8 to 15mm³/s extrusion test Does anybody have the g-codes extrusion test cylinder that runs from 8 to 15mm³/s ? Only one I can find is the 3-10mm³/s Share this post Link to post Share on other sites
robson 1 Posted April 10, 2016 in 8 to 15mm³/s extrusion test Bump Share this post Link to post Share on other sites
Dim3nsioneer 360 Posted April 10, 2016 in 8 to 15mm³/s extrusion test https://ultimaker.com/en/community/6436-a-tougher-extrusion-test-o?page=1&sort=#reply-143029 Share this post Link to post Share on other sites
robson 1 Posted April 10, 2016 in 8 to 15mm³/s extrusion test Thank you! Share this post Link to post Share on other sites
robson 1 Posted April 10, 2016 in 8 to 15mm³/s extrusion test Can I save these g-codes as .txt and copy them to sd card, or do I need to convert them somehow? Sorry but I'm a beginner and didn't find an answer Share this post Link to post Share on other sites
IRobertI 428 Posted April 10, 2016 in 8 to 15mm³/s extrusion test gcode is the format that the printer uses, so just put it on the card and you're good to go. Share this post Link to post Share on other sites