It has been said it's down to the feeder as it pretty much stops because the flow rate is so small. So if you are printing at 30mm/s then a 0.4mm nozzle will be printing at 0.24mm3/s
And a .25 nozzle with the same settings will be printing at 0.15mm3/s which is very slow indeed.
But in saying this I have successfully printed models with a 0.25mm Nozzle at 0.04 layers like the frog below. I have used 0.02 layers but it ended up with 2 many blobs.
Recommended Posts
AreDigg 8
Probably spelling mistake.
Link to post
Share on other sites