Gluing 4mm flat object together

[kvcrf250 1]

H i all

I'm Fairley new to 3d printing and after getting an Ultimaker Extended 2+ from ultimaker GB this year and with lots of help from Shaun Pullford i have manage to produce my objects but had one problem.

This was gluing 4mm flat sections together end to end, after many failed attempts i have got it

.

.

The Glue is Loctite 401

i smear a layer to both items then glue together holding them in place for 24 hours with strong dukt tape then hey presto like one sollid piece, i just have to sand the slight ridge that is formed.

Hope this helps someone.

All the best you printers

kev.

[Labern 774]

Also Acrylic glue works well for PLA as it slightly melts the surfaces together.

You can use Acetone for ABS.

Edited July 21, 2016 by Guest

[JohnFox 25]

I've used Araldite, it's a two part epoxy resin. You have to mix it up for each use but you have time to align the parts. The thinner the epoxy layer the better.