Jump to content

cura and weight


neone

Recommended Posts

Posted · cura and weight

Hi all,

Some time ago I had a cura version (can't remember which one) that included info on the weight of the piece.

I can't seem to find it on the newer versions though. Is there a way to see this info some way?

I'm planning to make some other pieces with a fixed weight.

  • Link to post
    Share on other sites

    Posted (edited) · cura and weight

    eHbdoMC.png

    The weight did show in all versions of legacy Cura, and have not been visible in any version of Cura 2, but it is back now with the 2.3 Beta version released the other day.

    Edited by Guest
    • Like 1
    Link to post
    Share on other sites

    Posted · cura and weight

    Hmmm.... would be great to have it also in the gcode file similar as in the old versions.

    I saw some setting information at the end of the gcode, but there is this info not included... :-(

    Maybe there is a quick hack for this available...? :-)

  • Link to post
    Share on other sites

    Posted · cura and weight

    :-( ok, but I slice it for UMO...

    Additional info in the gcode for reading it with e.g. the editor might be good as you can quickcheck "older" files regarding needed material quantity or print time (e.g. for making offers...) when produced again...

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...