Jump to content

Printcore 2 lever not aligning with switching bracket


Euan12345

Recommended Posts

Posted · Printcore 2 lever not aligning with switching bracket

Firstly I hope I've posted this in the correct section.

I received my um3 extended this week and seem to be having an issue when it goes to move the lever to move print core 2 up and down. For some reason it isn't aligning with the slot on the white bracket on the y axis. It keeps pushing the lever into the side of the bracket in front of the slot.

I managed to get through an active bed levelling by flicking the lever manually and have completed a couple of prints, which I am very happy with.

The white bracket appears to be attached correctly to the side panel and as it has two dowel holes can only go in one position. So I'm wondering is there is some setting I can adjust so the printhead will go to the correct location?

Apologies is this has been posted before, I did try searching but had no luck. Possibly not using the right keywords.

  • Link to post
    Share on other sites

    Posted · Printcore 2 lever not aligning with switching bracket

    This is easy to fix - you can calibrate the location of where the switch goes into the core switcher thing.

    It's in the menu system somewhere. It shouldn't be hard to find.

  • Link to post
    Share on other sites

    Posted · Printcore 2 lever not aligning with switching bracket

    Hi gr5,

    Sorry for the delay replying. I found the setting in the menu and sorted it out quickly.

    However after printing a part that should have had a circular section and it came out quite oval I found that the rod that passes through the print head on the x axis was about 3mm out of line from one end to the other! I assume this is what caused the switch not to line up in the first place.

    I have now adjusted the machine to get this rod nice and parallel and then reset the position of the switch just to be safe.

    Many thanks for your advice.

  • Link to post
    Share on other sites

    Posted · Printcore 2 lever not aligning with switching bracket

     

    @Euan12345 it could be really helpful if you report this issue yo your reseller so they pss note to UM if your x/y wasn't square. Just in case also check that the short belts are tight since that can also create ovals while printing circles.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...