Jump to content

Tinker firmware - UM2+ Extended getting ER07 on home head with 16.12.1


markusmaker

Recommended Posts

Posted · Tinker firmware - UM2+ Extended getting ER07 on home head with 16.12.1

Hi there!

I immediately get a "ER07 Error Stopped X or Y switch broken" on home head.

With original firmware everything (including printing) works fine. Its a UM2 Extended which has been upgraded to Plus (by myself).

Before the printer was upgraded I used a older TinkerFirmware on it. I think it was 15.10.x.

I also tried 16.03.1 but same issue.

See

https://www.dropbox.com/s/v3h8kklk25viyux/originalfirmware.mp4?dl=0

and

https://www.dropbox.com/s/7qvtn6skva6c5eo/tinkerfirmware.mp4?dl=0

Anyone with the same issue?

  • Link to post
    Share on other sites

    Posted · Tinker firmware - UM2+ Extended getting ER07 on home head with 16.12.1

    Installing the recent original firmware corrupts some of the stored "tinker settings" (and vice versa).

    Check (at least) the preferences for "Print area" (or make a factory reset to restore the defaults):

    https://ultimaker.com/en/community/22363-help-upgraded-tinkergnome-firmware-now-i-get-x-or-y-switch-broken

  • Link to post
    Share on other sites

    • 1 year later...
    Posted · Tinker firmware - UM2+ Extended getting ER07 on home head with 16.12.1

    This (old) post also solved my very frustrating problem following a firmware update after replacing the hot end and having half the machine apart.  I'd assumed I'd broken something, but after testing the switches was starting to fear I'd need a new mainboard.  Factory reset did the trick.

    Breathing a huge sigh of relief now.  Thanks to @tinkergnome and the OP!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...