Removing the Bowden Tube from the Head

[jleichne 0]

Hey!

So I want to remove the Bowden tube from the hot head so I can attach it to a new mount for a syringe-extrusion setup.

How do I go about pulling it out? Do I need heat? Do I need to hold down a little white thing like when you remove the bowden from the back extruder?

Thanks! I'm cautious about pulling too hard before asking the community.

Jared

 

[IRobertI 521]

Remove the blue horse shoe, push down on the white piece as far down as it will go and you should then be able to pull the bowden out.

 

[dmolina 4]

Hey, thanks a lot, I was putting some force into it, glad I read this before doing something stupid! :cool:

 

[DesignCreateEducate 0]

I tugged a bit too hard as well I am sure.

Now...how far do I push it back in to replace it? Thanks for any advice.

[DesignCreateEducate 0]

K I think I got it...I just push until it runs into the nylon? white part and can go no farther. Why is there no d'oh emoticon?

Cheers - S