Make sure support is not only unselected, but that it is coupled to extruder 1. So first turn on support, select extruder 1, and unselect it again.
Also, make sure that brim/skirt is printed with extruder 1.
Not very logical, but this is how it works now.
Just thinking, did you try if you can make/update a nozzle 1 only (or nozzle2 only) profile after you did this trick, so we have a quick solution until the bug gets fixed?
Recommended Posts
tomnagel 126
Make sure support is not only unselected, but that it is coupled to extruder 1. So first turn on support, select extruder 1, and unselect it again.
Also, make sure that brim/skirt is printed with extruder 1.
Not very logical, but this is how it works now.
Link to post
Share on other sites