I think you are correct about adding the raft height.
This plugin has always been kinda buggy for me. I use it a lot, you have to put in the exact Z height and it's best to account for slicer rounding.
for example...if you have 1st layer=0.3mm and are slicing at 0.2mm you will never have a layer at 20mm, you will have a layer at 19.9mm and a layer at 20.1mm. The plugin has to choose where to do the pause.
ALSO - it always breaks horribly if you try to do more that one pause in the print. This has always been an issue. I just jams all the pauses into the same space, ignoreing any height info you're given it. But works good for a single pause.
Recommended Posts
Nicolinux 288
Hi, and welcome to the forums.
I never tried the plugin with raft but I think this might be the problem. Try to print a simple object without raft and validate your idea about pausing at the right layer height.
Link to post
Share on other sites