Hi it's me again..
I was just wondering if you loaded two different .stl files or just one?
As far as i got it, you would have to load a "support structure"-file and a "part"-file.
Have you been trying this file http://www.thingiverse.com/thing:23008 or any other print containing two .stl-files?
Sorry if this is not your problem but thought that you might have bet it wrong since you are usually not working with cura.
Regards
Ji
Recommended Posts
snowygrouch 1
So as mentioned elsewhere the 2nd extruder does "work" as I tested it with KS by just selecting "extruder 2" for everything.
So here is the code that CURA 13.03 is supposed to insert during extruder change, BUT if i look in the GCODE output none of these lines appear in the GCODE...
I assume there is some setting or something somewhere that I am supposed to make....
Link to post
Share on other sites