thanks very much, I'll try that.
-
1
thanks very much, I'll try that.
That is probably it. By pushing it in with the sleeve pulled back, it will snap in place and you won't be able to pull it out. Good luck! (also check that you don't insert it upside down).
That is probably it. By pushing it in with the sleeve pulled back, it will snap in place and you won't be able to pull it out. Good luck! (also check that you don't insert it upside down).
Holy crap! I have owned a Ultimaker 3 since release and never knew this. I resorted to printing a bracket to hold the cable in place securely.
Recommended Posts
Dim3nsioneer 558
make sure the connector is fully plugged in. it has a safety function against falling out. you may have to pull back the cover of the connector to be able to fully plug it in.
Edited by GuestLink to post
Share on other sites