Go to cura settings (not profile settings) and there's a checkbox - make it so cura allows Z to go negative. Then click on the part and the "move" icon and set the Z to a slightly negative value. Maybe -0.1mm. This will probably fix your issue.
Sounds like a great place to start... thank you for the advice... it was strange to me that the software update all of a sudden brought this issue out... I currently have a 4 day tpu print going right now so I'll post my results when I can start a new model...
Thanks again and I'll keep you posted
Recommended Posts
gr5 2,224
Go to cura settings (not profile settings) and there's a checkbox - make it so cura allows Z to go negative. Then click on the part and the "move" icon and set the Z to a slightly negative value. Maybe -0.1mm. This will probably fix your issue.
Link to post
Share on other sites