Thank you,
I did have the ignore small Z gaps checked, but unchecking didn't make a difference and fill gaps between walls is set to everywhere.
I don't want to slice the model thinner as it already takes 19:13 hours to print. Any other hints?
Thank you,
I did have the ignore small Z gaps checked, but unchecking didn't make a difference and fill gaps between walls is set to everywhere.
I don't want to slice the model thinner as it already takes 19:13 hours to print. Any other hints?
Does anything change when you up your wall count to say maybe 4?
Recommended Posts
Camaroboy383 1
under the shell setting is your ignore small Z gaps checked? if it is uncheck it and see if that generates the same gaps in the model...
also check to be sure your FILL GAPS BETWEEN WALLS is set on EVERYWHERE...
possible slice the model at .06 if all else fails and see if it corrects the issue... only problem with that is it will for sure add lots of time to the print..
just grasping at straws here...
Link to post
Share on other sites