Jump to content
Ultimaker Community of 3D Printing Experts
4DMaster

CURA 3.0.3 hangs on slicing ( preparing ) - MacOSX 10.11.16 ElCapitan

Recommended Posts

I was really excited to start working with CURA 3.x but unfortunately it behaves as the CURA 2.7 and hangs on slicing ( preparing ). That said, on CURA 2.7 I have been able to slice intermittently. Basically I had to install the CURA 2.7 authorize the software for security and get one or two prints done. Then, no go on slicing. So, I reinstalled to get a couple more prints done over n over again. Now, the CURA 3.0.3 doesn't even slice that first model. Anybody else experiencing this ?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!