Reinstall firmware without problem solving:angry:
Some version combinations of Cura and firmware caused problems since Cura overwrites the material profiles on the printer.
Do a factory reset on the printer, this will create a fresh copy of the material profiles on the printer.
Use Cura v2.7 or newer to prevent this problem from recurring.
-
1
Thank you for your support.
-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
Dim3nsioneer 558
Reinstall firmware please.
Link to post
Share on other sites