Jump to content

USB connection causing printer to restart continiously

rebekah_harper

By rebekah_harper
in UltiMaker 3D printers

 Share

Recommended Posts

rebekah_harper

rebekah_harper 60

Posted
Posted · USB connection causing printer to restart continiously

Hiya,

I built my own PC due to much needed power for CAD.

However now my UM2+ keeps restarting until I manage to connect Cura or S3D just at the right time.

The only thing that has changed is that I now only have USB 3 ports but unless there is in the back ground that differs from USB 2 I couldn't say.

I have checked the BIOS for auto settings etc... but nothing that appears out of place or something that could solve this.

check USB setting in Win10 again nothing there that suggests auto connect etc... driver appears to be correct, and it does connect with the driver.

many thanks

Rebekah Anderson

    • Link to post
    Share on other sites
    ahoeben

    ahoeben 1,948

    Posted
    Posted · USB connection causing printer to restart continiously

    Best solution is to not keep your UM2+ connected through USB, and print with SD-card or with OctoPrint installed on eg a raspberry pi.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...