UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
rebekah_harper 60
Ok I assume that the G-Code files are not newly generated ones after the problem G-Code?
I would suggest you use a different model and generate a new G-Code and see if it happens.
when you say the build plate doesn't move. I am hoping that all axis go to Home this being the build plate goes to the bottom.
if not, what height is it at when it start printing? is it the height it was priming the nozzle at?
just to confirm it's the UM2+ ?
if so sometimes I have to just turn it off and then on again and on two occasions I had to do a factory reset.
you may need to reinstall the latest firmware but that is easy enough through USB or Card
Link to post
Share on other sites