Jump to content
parkeagle

Fan speed settings custom material and profile not applied

Recommended Posts

Posted · Fan speed settings custom material and profile not applied

Hi,

I've set the initial fan speed to 0% and the regular and maximum fan speed at 5%. I notice the fan is still on at the first layers and is spinning quit fast.

I'm using a custom material.

It seems the profile settings aren't really loaded when overriding the current loaded material with a custom material and profile?

I'm using a UM3 with Cura 3.0.4.

Share this post


Link to post
Share on other sites
Posted · Fan speed settings custom material and profile not applied

Well.. the initial fan spinning will just be temp control as it doesn't want to heat the printcores too fast.

It shouldn't effect your print. 

Share this post


Link to post
Share on other sites
Posted · Fan speed settings custom material and profile not applied

Are you talking about the side fans or the front fan? The front fan should spin as soon as the cores start heating up. This is intentional and is to prevent heat from travelling up too high in the cores (not to prevent them from heating too fast).

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!