SOLVED Cura 3.x - bottom hole ignored

[zfiser 0]

hello,

 

the new 3.x version slicer seems to ignore bottom hole, please see image for reference and comparison with 2.7.

model is also attached, original from https://www.thingiverse.com/thing:201052

 

is there some setting for it?

thank you

Egg_Cup_Drive_Sucker_Longer.stl

[burtoogle 514]

It works OK with the latest development code which isn't that far removed from 3.x:

 

[kmanstudios 1,120]

It slices fine. Make sure you do not have "Remove all holes" checked. See image for slice and setting I am talking about.

[zfiser 0]

Thank you all for your replies. 

 

Mine really didn't slice it properly, tried both 3.1.0 and 3.0.4 versions, even I had the "Remove all holes" unchecked.

 

Resetting profile settings to default helped, so I compared the before-reset/after-reset settings and found out that it was caused by "Make Overhang Printable" option enabled.

 

thanks again for your help.

[kmanstudios 1,120]

glad you found it.