Jump to content

Problems with printing Tower or Parts


Sand64

Recommended Posts

Posted · Problems with printing Tower or Parts

HI All,

i have a Moder of a Tower that i want to print but in Cura only the support Strukture is printed. 

In the Normal View everythink is fine. I know the Model is complicated / impossible to print.

And i also splitted this Tower in many smaller parts. but i got the same Problem.

Even when i try to Print only one part. 

can someone please check the File and explain to me why Cura is not accept the Model for Printing?

thanks a lot,

Jonny

 

Tower.3mf

  • Link to post
    Share on other sites

    Posted · Problems with printing Tower or Parts

    I downloaded the model and it is 0 bytes. If you saved it out of Cura, then save using "Save Project' save everything. The best thing to do is to zip up the STL files so they can be examined outside of Cura. Many of us use different packages and that gives you much more of a range of perceptions and results. :)

  • Link to post
    Share on other sites

    Posted (edited) · Problems with printing Tower or Parts

    Ok, that worked well. I did get a look at the model and the thing I see is that the structure is too tiny for the nozzles to be picked up. I even reduced line width to 0.24 and it barely picked up the intersections of the crossing members.

     

    Edit: Additional info

     

    Using horizontal expansion at 0.2mm I got a lot of it to register.

    Using horizontal expansion up to 1mm got more, but looked really bad and still did not do it.

     

    Scaling up to 277% and horizontal expansion of 0.2mm did well.

    Even scaled up to 300% required horizontal expansion of 0.2mm to get the top parts to be seen.

     

    So, short answer is the parts are too thin to be sliced at current size.

    Edited by kmanstudios
  • Link to post
    Share on other sites

    Posted · Problems with printing Tower or Parts

    Thanks a lot for your Answer.

    It was not possible to find another Tower like this. but yes. the File was in a Original Size.

    Means with this File i will do not have any Chance to print, right ?

     

    Where is the Setting of Horizontal Expansion ?

    thanks in Advance

    Jonny

     

  • Link to post
    Share on other sites

    Posted · Problems with printing Tower or Parts

    Horizontal expansion is in the shell part of the side menu on the right. If you were to make it larger and break it up some more than you may be able to strike a balance. But,yes, as is, it is to thin to print.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...