Jump to content
Ultimaker Community of 3D Printing Experts
DragonDon

Cura not seeing 101 Hero on MacBook Air

Recommended Posts

I have a 101 Hero 3D printer.  It worked fine on my old Win 7 Laptop (till that started acting up....) then I saw that Cura would run on OS X.  So, picked up a MacBook Air (10.13.2), installed the OSX VCP driver, and can see "CP2102 USB to UART Bridge Controller" show up when I plug the printer in but Cura can't see the printer.

 

I have tried Cura 3.1 and Cura 15.04.06 and neither recognize the connected printer.

 

I'm at a loss where to go to next.  The USB port works fine with anything else.

 

Could reeeealy use some guidance on this.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!