Jump to content
Ultimaker Community of 3D Printing Experts
Torgeir

The famoust first level.

Recommended Posts

Hi Folks,

 

Here is the difficult first level, just zoom in and see how close it is..

This is how much I'll squeeze it..

 

5a594eaa23e63_20170217_1734481.thumb.jpg.5154899fff604436eab7965a42915fc9.jpg

 

This is pure black filament, so you see how tiny the layer is.. 

After this way of squeezing, I've never have any prints lift off, but it is hard to get off. Just wait until it is cold. 

 

The calibration paper I'm using is the kind of receipt from the ATM..   Ops.. (Standard paper is 0.15 mm approx. and ATM paper 0,07 mm)

 

Thanks.

 

Torgeir.

 

 

 

 

Edited by Torgeir
Corrected.
  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!