4 hours ago, gr5 said:What is your layer height here? Maybe try a bit thicker layers? Is the fan working? I'm not convinced it's underextrusion. maybe retraction settings or hardware issues. Maybe your layer height is simply too thin.
i'm using 0.2 mm layer height, the fan is working fine.
it could be the retraction as this thing happens where the layer starts. maybe it tries to start the layer before it starts to extrude? how could i resolve this?
Recommended Posts
gr5 2,224
What is your layer height here? Maybe try a bit thicker layers? Is the fan working? I'm not convinced it's underextrusion. maybe retraction settings or hardware issues. Maybe your layer height is simply too thin.
Link to post
Share on other sites