Specify auto0.g as the filename for gcode?

[lordnimon 1]

My printer looks for a file named auto0.g on the SD card to print.  Would it be possible to configure Cura to always use that filename, instead of what it does today?

[nallath 1,123]

Not without changing code.

[lordnimon 1]

How do I make an official feature request?

[ahoeben 1,953]

See http://github.com/ultimaker/cura/issues

I don't think this has a high chance of receiving developer attention though, since it is such a niche feature for your printer. You can already type the name in the lower right corner (above the size indication)

[lairdb 3]

1 hour ago, ahoeben said:

See http://github.com/ultimaker/cura/issues

I don't think this has a high chance of receiving developer attention though, since it is such a niche feature for your printer. You can already type the name in the lower right corner (above the size indication)

 

Can't change the extension, though.

[catohagen 41]

11 hours ago, ahoeben said:

niche feature for your printer

its the autostart in Marlin firmware, so basicly every printer that runs marlin firmware supports it, I would hardly call that niche, I use it on my Ultimaker all the time  

[lordnimon 1]

This was requested as a feature a while back, someone wrote some code, but apparently it went nowhere. https://github.com/Ultimaker/Cura/issues/1059

 

I guess I would need to write the code myself if I want it fixed.