20 minutes ago, Nicolinux said:I think Cura is confused about how the parts are grouped/merged together. Did you assign different extruders to different parts of the model? You can check that if you tick off one extruder in the Layer Preview and see if it disappears.
And how did you group the objects together? Using merge or group?
Yep. Extruder 1 for the main body and extruder 2 for the smaller parts (Ears, tail, feet and chest parts).
I used merge to merge the two sets of objects together. It's weird because when I turn on the second extruder with both objects ungrouped, it cuts off at the ears:
I did edit the ears in the model not too long ago to see if it was the size of the object, but same thing happens.
Edited by SloverStudios
Recommended Posts
Nicolinux 288
I think Cura is confused about how the parts are grouped/merged together. Did you assign different extruders to different parts of the model? You can check that if you tick off one extruder in the Layer Preview and see if it disappears.
And how did you group the objects together? Using merge or group?
Link to post
Share on other sites