Jump to content
Ultimaker Community of 3D Printing Experts
Galad

Head included with Upgrade kit for UM2E+

Recommended Posts

Morning,

 

I've previously installed the upgrade kit and has worked awesome for some time.  We've had a recent mishap where the ID threads for the nozzles have been contaminated with PLA.  It's been cleaned since, but I'm curious: If I want to replace that head, what part would I order?  Is it essentially the Olsson block?

 

Thanks

Share this post


Link to post
Share on other sites

Yes.  The Olsson block.  I sell them in USA at thegr5store.com.  I also sell a slightly better version called the "block v3" which has less heat loss to air and better heat conduction to the nozzle.  

 

But you should be fine.  Just always change the nozzle when it's at least 130C.  I usually change the nozzle at 150C to 180C.  And you can ignore the plastic in the thread.  Also I recommend you use a torque wrench at around 0.5 to 1.0nM.  This one works great:

https://www.youmagine.com/designs/nozzle-torque-wrench

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!