Jump to content

Recommended Posts

Posted · Cura Flow and Ultimaker 3 flow

Hi.

I am trying to setup my printer properly, and I noticed that the fan speed set in Cura matches the reading in my UM3, but when I increase the flow to for example 105% in CURA, it only shows 100% in UM3, and I am not sure if it should show the number set in CURA (105%).

I want to make sure that the flow is increasing to tune up my filament properties.

Is this normal, or it is a glitch???

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 7 replies
    ×
    ×
    • Create New...