Project X

[Kurt Plagge 11]

This is something I've been working on for a while in between other projects. Only a specific sequence of steps will allow access to its secret compartment. Check out the YouTube video linked below to see it in action. 

 

Designed in Sketchup and printed on my UM3, it's made up of 36 individual pieces which snap together.

 

I used a variety of filaments:

• Ultimaker Nylon, Transparent and Black
• Ultimaker ABS, Orange, Green and Gray
• Faberdashery PLA, True Lagoon and Glacier Blue 

 

YouTube Video, Project X

 

 

 

 

 

 

Edited August 26, 2018 by Kurt Plagge

[gr5 2,172]

Awesome!

[gr5 2,172]

Are you going to post the STL files?

[Kurt Plagge 11]

I hadn't considered it but I could probably gather up the files and make them available. I wasn't very organized in my file keeping so it may take me a little while. Thanks!

[cloakfiend 995]

That looks amazing, you should send it to mr puzzle! on you tube!

[kmanstudios 1,120]

Impressive!

?

[Smithy 1,144]

Thats totally amazing! Great!

[Nicolinux 288]

+1 for sharing the files. I'd print it in a heart beat!

[Kurt Plagge 11]

OK, I finally have the files uploaded to the 3D Prints section. Due to the number of pieces and the complicated assembly process, I created a YouTube video that goes through putting it together, plus some other important information to help make the process more successful. 

 

Keep in mind that printing all of the pieces requires about 150 hours of print time and lots of PVA support, so proceed bravely if you're up to it!