Jump to content

Taz6, Gaps in walls and other issues when moving from Cura PE 21.08 to 3.2.27


micahsa

Recommended Posts

Posted · Taz6, Gaps in walls and other issues when moving from Cura PE 21.08 to 3.2.27

(Posted this over at the Lulzbot forums, /r/3dprinting, & /r/lulzbot)

 

We currently run a couple Taz6's using Cura PE 21.08. We've had a stable, quality print profile for well over a year but would like to upgrade Cura to the latest version to take advantage of new features. Every time I try and print using Cura LE 3.2.27, our prints have gaps in the walls, what looks like retraction issues, and I can't for the life of me figure out how to fix it.

I've tried the out of the box profiles, replicated as close as possible our current Cura settings from 21.08, and tried probably six different adjusted profiles, but nothing addresses the issues.

I've attached images of our current working profile and a few images of our cookie cutters that have gaps. That's pretty much all we print and all models have the same issues.

Any suggestions on how to clean thing up would be greatly appreciated!

IMG_4808.JPG

IMG_4809.JPG

IMG_4810.JPG

IMG_4811 (2).JPG

IMG_4812.JPG

IMG_4813 (2).JPG

  • Link to post
    Share on other sites

    • 5 months later...
    Posted · Taz6, Gaps in walls and other issues when moving from Cura PE 21.08 to 3.2.27

    You may get more response in the Lulzbot forums then here, because the LE versions are significantly different, and I think hardly anyone on this forum uses these versions.

  • Link to post
    Share on other sites

    Posted (edited) · Taz6, Gaps in walls and other issues when moving from Cura PE 21.08 to 3.2.27

    Your advice might very well work. We just don’t know, because of the changes in the LE versions.

    Edited by ahoeben
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...