Jump to content

Ultimaker Original Plus Filament läuft überall raus

3D-ProtoPrint

By 3D-ProtoPrint
in Deutsch

 Share

Recommended Posts

3D-ProtoPrint

3D-ProtoPrint 0

Posted
Posted · Ultimaker Original Plus Filament läuft überall raus

Hallo Freunde des 3D-Druck,

 

ich bin neu hier, nicht im 3D-Druck aber seit kurzem Besitzer eines Ultimaker Original Plus. Ich habe das Problem das wenn ich Nylon Drucke überall am Hotend Material austritt.

Ich habe schon alles festgezogen, jedoch ohne Erfolg, und hoffe das hier jemand mir Tipps geben kann wie ich das Problem beseitigen kann.

Vielen Dank.

 

Grüße

Sebastian von 3D ProtoPrint

 

UO+.jpg

    • Link to post
    Share on other sites
    zerspaner_gerd

    zerspaner_gerd 383

    Posted
    Posted · Ultimaker Original Plus Filament läuft überall raus

    Hallo Sebastian

     

    du müsstest mal schauen wo es raus läuft, evtl ist da was verschließen oder du hast genau diese stelle nicht festgezogen.

    Und nachdem einmal gesaut wurde reicht meist einfaches festziehen/nachziehen nicht mehr, sonder du musst es erst zerlegen und sauber machen

     

    Gruß

    Gerd

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Followers 1
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 20 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...