I have exactly the same issue! 😞
Hi, I have the same problem.
Since installing the latest firmware, the x/Y offset test doesn't print a prime blob for either nozzle and thus doesn't work.
me too 🤨
Is there any bug reporting location? I've tried emailing info@ultimaker.com but to no reply.
This effectively makes dual nozzle printing impossible so quite a major problem.
Same thing here! I have been struggling for 24hrs and was thinking that I was doing something wrong myself....
In the end I just loaded an xy calibration test model, which prints fine with prime blobs at the start, and so could finally do a proper calibration with my new print cores!
Great idea to work around this issue.
Could you share the link to download the XY calibration model.
Thanks.
https://www.thingiverse.com/thing:1451156
Here the link to the dual extruder calibration test model download 🙂
Recommended Posts
mmk 0
Link to post
Share on other sites